Description of YT28 Pneumatic rock drilling machine:
The YT28 rock drill machine is a kind of high-efficiency air leg rock drill machinery.
It is mainly used for blasting holes and other drilling works in quarries, railway
Construction, water conservancy construction, and defense project facility.
It is suitable for drilling and blasting under various rocks at any direction angles.
Blast hole dia is 34-42mm, and drill hole depth is 5 m.
This machine may match with Model FT160BD short air leg or Model FT160BC long air leg.
This machine has a transparent surface of an FY200B oil reservoir to regulate oil.
Features of YT28 Pneumatic rock drilling machine:
· Fit for wet drilling in medium-hard or hard rock.
· Grouped control mechanism, quick to start up, with "air on, water on, air off, water off" mechanism, convenient to handle
. Easy to maintain and repair
· Energy-saving and efficient, long service life of parts, parts highly interchangeable and reliable performance.
Main parts of YT28 pneumatic rock drilling machine:
If you want to learn more details about this machine, please contact :
Email: Jenny@ztmineequipment.com
Whatsapp:+8613201801998
Parameters of YT28 Pneumatic rock drilling machine:
| Machine weight | 26 | kg |
| Captain | 661 | mm |
| Cylinder diameter | 80 | mm |
| Piston stroke | 60 | mm |
| Working stroke | 0.5-0.6 | mpa |
| Impact frequency | ≥34≥37 | hz |
| Gas consumption | ≤55≤81 | l/min |
| Tracheal diameter | 25 | mm |
| Water pipe diameter | 13 | mm |
| Drilling head diameter | 34-42 | mm |
| Drill tail size(hexagonal X Length) | 22X108 | mm |
| Air leg length | 1400 | mm |
| Advance the journey | 965 | mm |
| Cylinder bore | 65 | mm |
| Quality | ≈14.4 | kg |
| FT160BC type air leg(long air leg) | ||
| Air leg length | 1800 | mm |
| Advance the journey | 1365 | mm |
| Cylinder bore | 65 | mm |
| quality | ≈16.9 | kg |
| FY200B-FY200C-type oiler | 200 | ml |
| quality | 1.02 | kg |
Fitting and removing the tool
Before fitting the working tool
1. Check that the tool shank is of the correct size and length for the chuck used.
2. The shank must be clean and the tool must be in good condition.
3. The suitable quenching hardness of the shank is HRC48-53. A harder end face will cause piston damage and breakage of the end face of the piston. If the shank face is too soft, it will be easily deformed by the piston, which will result in difficulty in removing the working tool.
3. Shank end face shall be flat and perpendicular to the axis.
4. Remove sharp edges from the shank's end face. A rough shank surface will cause premature piston failure.
5. Inspect the bits: Dull bits will slow down the drilling speed and overstrain the drill mechanism. When changing bits make sure that the new bit is the correct size to follow your previous bore.
6. Before drilling check that the flushing hole in the working tool is not blocked.
Hot Tags: yt28 pneumatic rock drilling machine with air leg, manufacturers, suppliers, factory, wholesale, buy, cheap, low price