(1) Operators at both ends should cooperate closely, especially when the operator at the inlet end is cutting the steel strand or putting on the guide cap, the operator at the outlet end should not put his hands on the control button to prevent accidental operation and injury.
(2) Workers at the inlet end first press the emergency stop switch before they can cut the steel strand with a handheld grinder and then put on the estimated guide cap
(3) During work, people should be prohibited from passing through at both ends to prevent the steel strand from popping out and hurting people.
1. Strand guide cap is used in the construction of bridges. It is set on the 15.24 steel strand and used with the piercing machine. The diameter is 15.6mm-15.7mm. It can be used repeatedly, as long as the construction person loves it. No problem for 5 times. The length is 6cm, and the sleeve is 3-4cm. There is no need to use this strong sleeve. The 15.24 steel strand guide cap is easy to use and not easy to damage the strand. Can effectively protect the stranded wire head
2. Normal work: Pull out the steel strand with the guide cap from the cage, loosen the hand wheel, and thread the steel strand into the wire inlet of the strand threader, and pass it out from the wire outlet. Put a rubber guide cap on the other end of the stranded wire, and press the handwheel tightly, but not too tight, so as not to affect the life of the stranded wire guide cap. A lot of experience in wearing beams is summarized. It can be put on by hand without using a rubber hammer. It can also be reused, saving a lot of manpower. Only one person is up and down, which saves personnel management.
3. Simple operation, accurate data, no waste, greatly saving material costs.
4. The strand guide cap does not need to be cut and stored in advance to ensure material quality.
Shaanxi Zhongtuo Mine Equipment Co., Ltd. Supply high quality PC strand pusher machine.
Contact summer@ztmineequipment.com for more information!!!