The steel bar bending machine is an automatic device that can straighten and bend the steel bar. After the steel bar is formed, it will be cut off, which completes the processing process. If the steel bar cannot be cut, it will affect the use. What is the reason for the hoop machine cutting the steel continuously?
CNC steel pipe bending machine
During the use process, if the automatic steel bar bending machine does not cut the steel bar continuously, it will affect the normal processing and use and need to be dealt with immediately. The factors that cause this situation are as follows:
1. It may be that the shearing knife of the automatic steel bar bending machine is worn or damaged and needs to be replaced;
2. It may be that the gap between the shearing knives of the automatic steel bar bending machine is too large. It is recommended to adjust the compression bolts;
3. It may be that the motor belt of the automatic steel bar bending machine is loose and slipping, and a belt needs to be replaced;
4. It is possible that the diameter of the steel bar is large, the motor power is not enough or the cutter head is not sharp enough;
5. It may also be that the power source may be in poor contact, or that only low-voltage power should be used, resulting in insufficient power.
6. If the automatic steel bar straightening and cutting machine does not make a knife at all, it may be caused by the wrong length setting, or it may be that the diameter of the steel bar is too small and the steel bar straightening and cutting machine cannot cut it.