Instructions for giant splitting machine
In order to ensure the quality of drilling, reduce the labor intensity of rock drilling, and improve the efficiency of drilling, special rock drilling equipment, such as a sliding frame rock drill, should be used. For small mines without special rock drilling equipment, hand-held rock drills can be used for drilling, but the operator’s technical level should be greatly improved, and the drilling depth is limited to 2.0m, otherwise, it will be difficult for the drilling to reach the required accuracy and deflection.
The giant splitter uses the hydraulic power of the excavator itself and is directly mounted on the excavator's arm. It is not only convenient to move but also more than 10 times more efficient than a handheld hydraulic splitting machine. This machine is especially suitable for non-blasting large-volume rock excavation and ore mining. Such as urban building foundations, rock excavation, and rock excavation for high-belt highways under construction or expansion.
The principle and characteristics of giant splitting machine
Demolition of rock and concrete is more effective, avoiding many problems (such as vibration, noise, and dust) caused by traditional blasting.
Increase environmental protection, reduce material costs, and reduce material loss.
It can be used to excavate various rock excavations such as tunnel shafts and tunnels (subway, highway, railway, etc.), undercut excavation, ditches, buildings, etc.
In the overall rock fracture, it can replace the breaking hammer, and its power is 5-10 times of the breaking hammer.
There are two main construction methods for static exposure
The traditional construction method is to add some solids such as silicate and calcium oxide, add water, stir them into a solid, and then put it in the place to be filled, hydration reaction occurs, and the solid hardens, The temperature rises, the volume expands, and the rock swells and breaks, which is called static expansion agent and crushing agent. Due to the traditional static exposure method using an expansion agent and crushing agent, the cycle is long, the construction output is low, the requirement of the site is high, it is greatly affected by rain and temperature, and there are many factors such as spraying and strong alkaline hazards.
It is gradually eliminated in the construction process that cannot be used for exposure. The mechanized static exposure technology uses a static explosion giant splitting machine and uses hydraulic and mechanical methods to crack the rock. It is not a problem to split the rock every minute.
Precaution of operating ultra-large rock splitter
For your better use of our ultra-large rock splitters quarry to avoid undue failure of the hydraulic splitting machine, please be sure to observe the following when using the splitting machine and strictly observe:
1. After the hole depth reaches the standard, the splitter can be inserted into the hole for division;
(Hole depth requirements: splitter front end of the block length + 900mm or more, for example, split block length 600mm, then you must drill more than 1500mm holes can be used before the split machine)
2. Each splitter splits a certain grease after splitting 3-5 holes to reduce the friction between the wedge and the splitter;
3. Do not use the splitter gun as a crowbar to use.