A small automatic CNC steel bar bending machine is a high degree of automation equipment. The whole machine integrates machines, electricity, gas, and the main engine. The production process is basically completed automatically by system control.
Features of small automatic CNC steel bar bending machine:
1. There are many types of steel bars that can be processed, with diameters ranging from 6mm to 16mm, so they have a wide range of applications.
2. With high precision, the length tolerance of steel bar processing is controlled within +/- 1 mm, and the error of processing angle is not more than +/- 1 degree. This machining accuracy greatly exceeds that of manual operations.
3. The scope of work is large. Before the rebar is fed, whether it is placed regularly (such as a disc) or irregularly placed, it can be smoothly fed and straightened.
4. Can process hot-rolled and cold-drawn steel bars, whether it is in the form of discs or not.
5. Ensure the effective utilization of steel bars. Because it is controlled by a computer, it can process as much as it feeds, so the steel bar has been used to the maximum extent.
New CNC steel bar bending machine manufacturers
A small automatic CNC steel hoop bending machine is also known as an automatic steel hoop bending machine, CNC hoop bending machine, and CNC steel hoop bending machine. A steel bar bending machine is a kind of processing machine for steel bar operation. It is an extension of the rebar bending machine, which can achieve the specified angles and specifications more efficiently. When the hoop machine is in use, danger may occur from time to time, and you should prepare in advance to prevent it from happening.
When the hoop bending machine is working and the required camber cannot be achieved, check the high pressure for cutting. If the cutting at high pressure is abnormal, adjust the pressure according to the instructions; check whether the gap between the upper and lower knives is too large. It should be adjusted to about 0.2 mm; check whether the delay disconnection time and the relay time are adjusted short, if any difference is found, it should be set to 0.2~0.4 seconds; If the strength is too high, the user can use the previously hooped steel bar to cut it again on the machine, so as to distinguish the strength of the steel bar to be cut is greater than 750N.