The thread rolling machine is a kind of equipment for cold extrusion processing, which can complete various processing work on the workpiece. In order to make it work better in use, there are many aspects to pay attention to during installation.
1. When installing the thread rolling machine, make sure its grounding is reliable. It is best to install a suitable fuse device in the power supply. In order to make the operator safer during use, it is best to install a leakage protection device. In addition, it is preferable to introduce a power line to be buried in an installation form.
2. Open the electrical box equipment and carefully check whether all the internal terminals are loose. If you find a problem, tighten it immediately. The condition of the wires also needs to be checked to ensure that the wires are intact and that there is no problem with broken skin. When problems are found, they should be replaced in time.
3. During the trial operation after the power is turned on, you must pay attention to the operation of the hydraulic motor and ensure that it is clockwise. In addition, the cooling water pump is also a very important component. If the coolant is reversed, the coolant will not flow out, or there will be little coolant. Depending on the processor, the main motor can ignore the workpiece and rolling die used on the panel to decide whether to rotate left or right. If the phase sequence is wrong, simply change the two-phase line in the power line to this position. If the hydraulic and cooling water pumps are facing in the opposite direction, the tubing in the hydraulic motor terminal box can be replaced.
