U-shaped Steel Bracket Bending Machine For Mining

U-shaped Steel Bracket Bending Machine For Mining.

U-shaped Steel Bracket Bending Machine For Mining

The character of H type bracket arc bending machine
(1)Three driven rollers
(2)Bending rolls are high tensile alloyed forget steel, heat treated
(3)All welded steel frame, heavily proportioned and stress relieved
(4)Digital read outs for the position of the lower rolls
(5)The three-roll double-pinch type uses one fixed roll and two moveable rolls. Rolls adjust to bend symmetrically or asymmetrically and pre-bend both ends of the work piece in a single pass. Bending distance- the distance between the tangent contact points of the rolls- increases with the diameter rolled, broadening the capacity of the machine.
(6)Guide rolls are hydraulic-driven and adjustable in up/down
(7)Shafts in alloyed steel, heat-treated and ground, mounted on long-life grease-lubricated self-alignment spherical roller bearings
(8)With emergency stop buttons
(9)All motors have a corresponding breaker to protect from short circuit caused by over electricity
(10)All motors have a corresponding heat relay as protection against overload

Send Inquiry

U-shaped Steel Bracket Bending Machine For Mining.

Description:

WGJ-U steel bending machine on the old U-shaped steel arch can be repaired, molding reuse, to overcome the existence of a series of defects in the repair, with high repair efficiency, the loss of U-shaped steel strength, high precision, and then after molding, Without skirt and other advantages.

Application: