Description
|
Rock Splitter Hand-Held Concrete Splitting Machine is a kind of hand-hold splitting and demolition tool.
It can controllably split rock or concrete. Especially suit for the cabined area where large machine can not work.
Such as hydraulic breaker and place where is strictly limited noise, dust, flying debris, shake exhaust gas. |
|
Technical Parameter of Rock Splitter Hand-Held Concrete Splitting Machine
|
Model |
Wedge Length mm |
Drilling Diameter mm |
Drilling Depth mm |
Rated Pressure MPa |
Splitting Force T |
Power KW |
Weight kg |
|
ZT250 |
250 |
38 |
450-500mm |
60-80 |
300 |
4 |
35 |
|
ZT350 |
350 |
42 |
700mm |
60-80 |
400 |
4 |
35 |
|
ZT450 |
450 |
46 |
900-1000 mm |
60-80 |
600 |
4 |
35 |
How to use the Rock Splitter Hand-Held Concrete Splitting Machine?
First, a hole of precise diameter and depth is drilled into the material. The wedge set (one wedge and two counter wedges) is inserted into the drill hole.
The wedge is driven forward under hydraulic pressure, forcing the counter wedges apart with a force of up to 600 tons. The material splits within seconds.
With enlarging counter wedges the split can be expanded to its maximum width. Reinforcing rods break or can be cut up with a suitable power tool.
The applications for the splitter are many, such as bridge decks, abutments, retaining walls, concrete walls, floor slabs, foundations, wall openings, reinforced concrete, rock and brick walls, locks, dams, culverts, road barriers, and underwater demolition of concrete and rock.
features of Rock Splitter Hand-Held Concrete Splitting Machine
1. About drilling: drilling must be perpendicular to the split surface, the depth of the hole is more than 500mm, otherwise it will causethewedgeblocktobreakinthemiddlewedgeblock, so that the whole split machine can not be used.
2. About the radial direction: ban by shaking the hydraulic cylinder to split die insert, press the split cylinder swing ban splitting process. Otherwise it will lead to deformation of the piston rod and the cylinder seal, the hydraulic oil leakage. In and out as far as possible when light splitting machines take slow, moving through the handle before andafter handling.
3. Open hydraulic cylinder piston rod and the cylinder to replace the seal,thetopofthepistonrodwithahydraulicpump,the piston rod ejection, certain to repeatedly tap switch, hydraulic pump on hydraulic cylinder around a distant location. Before the operation, banned the use of hydraulic cylinder upright, hydraulic cylinder must be placed on the ground level, staff can not stand in the front or rear, must stand in the hydraulic cylinder around a distant location, to prevent the piston rod by the strong thrust flying out to hurt people.
4. The inspection of fasteners: check the fastener on the body of the body of the pump before use, and find that the loosening should be fastened in time.
5. With regard to the working pressure, the working pressure of the power station and the split gun of this split machine should not be adjusted privately by 63Mpa.
Hot Tags: Rock Splitter Hand-Held Concrete Splitting Machine, manufacturers, suppliers, factory, wholesale, buy, cheap, low price