Reinforced Bar Forming Machine

The use of Reinforced Bar Forming Machine:
1. Cut the steel bar according to the unfolded length of the eight-shaped bar.
2. On the steel bar processing platform, manually bend into a rectangular box according to the size requirements, and the joint is left in the middle of one long side, and the overlap is about 20mm.
3. Two heart-shaped frame-blocks are nested on the rectangular box horizontal platform formed by the bending of the mortar, making the front and back symmetrical. Turn on the hydraulic jack on the overlap side of the rectangular box joint to push the steel bar to the position where the two heart-shaped tips are opposite. At this time, the overlapped part of the steel bar expands and reaches the position where the cut surface of the steel bar is just opposite (the interface when processing the rectangular box It takes several times to achieve this effect), start the jack at the other end, push it over, and the two sides of the steel bar are together to form a 3cm parallel part. After welding together, retract the jack and remove the forming machine Figure 8 ribs, proceed to the next processing.
4. Formation of figure-eight ribs: the slurry removes the figure-eight ribs of the platform, welds them according to the designed weld length and welding requirements, and immediately puts them into a vertical press mold after welding.

The processing flow of the eight-character grille frame:
1. Determine the blanking length according to the drawing of the figure-eight grid frame.
2. Bending the sheared steel bar.
3. Weld the bent steel bars.
4. Use hydraulic equipment for the plane extrusion of welded steel bars.
5. Weld the extruded steel bars.
6. Perform vertical extrusion on the welded plane figure 8.
7. Weld the double horoscope to become a horoscope knot.
8. Manufacture the eight-shaped rib grille steel frame on the fixed mold

Product parameters of Reinforced Bar Forming Machine

Technical measures and operational points:

1. grid arch installation

(1) option. Select the required unit according to the construction site.

(2) lifting. The selected unit is lifted from the stack with electric machinery to the working surface. This process is concerned with protecting the grille from bending and tearing.

(3) the initial position. Artificially transported to the face of the grille by the position of the first place in place. And the units are bolted. semi-automatic bar bending machine Do not twist in order to adjust.

(4) review. Once the grid is in place, check it immediately. The main review center line and elevation, timely adjustment, to achieve the correct meet the design requirements.

(5) positioning check after passing, tightening the connection bolts, and welding with the positioning of a solid.

(6) connection. Grille positioning, the timely welding of longitudinal connecting ribs, and the former strong welding, grille, and anchor connection must meet the requirements.

2. Character of reinforced bar forming machine| tunnel eight-character bar machine operation and installation process review, connection for the operating points, it must meet the following requirements:

(1) grille clearance must meet the design requirements, not infringing.

(2) grid elevation must meet the design requirements.

(3) bolts must be tightened.

(4) The connection of the connecting ribs and the connection between the bolts shall comply with the construction codes and regulations of bar bending machinery.

(5) accurate review of mileage, to avoid the installation of the vertical phenomenon of grid staggering phenomenon.

Hot Tags: Reinforced Bar Forming Machine, manufacturers, suppliers, factory, wholesale, buy, cheap, low price